See Tech Video 

LaserJet 4100N 49.4C02 error message

 

Often times this error appears after a new firmware DIMM has been installed.  It is clearable by performing an NVRAM initialization.  On this model printer, perform the following procedure:

To initialize NVRAM:

1 Print a configuration page and a menu map.

2 Turn off the printer.

3 Remove all formatter accessories (EIO cards, hard drive, DIMMs, etc.).

4 While turning on the printer, hold down SELECT and CANCEL JOB until all of the lights on the

control panel are lit.

5 Press CANCEL JOB, and then SELECT. The NVRAM INIT message appears on the control panel

display.

6 After initializing the NVRAM, use service mode to reenter the settings from the configuration page.